Automobile Enthusiasts

sorefeet

(1,241 posts) Sat Nov 21, 2015, 04:55 PM Nov 2015

Any of you folks rebuilt a Muncie

I got a Muncie M20 that I'm putting in a 63 Ranchero gasser. It needs the front input bearing and you have to take the whole thing apart to do it. So I figured if I have to take it apart I might as well put a new rebuild kit in it. OH, I can get it apart, BUT, can I get it back together??????????? I can get a deluxe kit for about $135 bucks.

1 replies

= new reply since forum marked as read

Highlight:

Any of you folks rebuilt a Muncie (Original Post) sorefeet Nov 2015 OP

Have you done anything like this before? Mopar151 Nov 2015 #1

Mopar151

(10,004 posts)

1. Have you done anything like this before?

Reply to sorefeet (Original post)

Mon Nov 23, 2015, 12:38 PM

Nov 2015

do you have GOOD snap ring and expanding ring pliers? Can you get things (bearings) removed and installed with a press?
If you have that stuff covered, get a book or Motor Manual/Chilton, lay some clean newspaper on the bench, and have at it!

Reply to this discussion